AES 7170 Manual do Utilizador descarregar pdf (Página 24)

40-7705I-UM Page 24 Rev 4 March 16, 2007

5.9 Setting Time:

Time is very important and somewhat complex in a MultiNet System. Use the

Linux date command to set the time as shown in one of the following examples:

Where hh = hour mm = minutes .ss = seconds

MM = month DD = day CCYY = 4 digit year

date MMDDhhmm.ss<Enter>

date MMDDhhmmCCYY.ss<Enter>

date 10031055.00 Sets the time to Oct 3, 10:55:00 AM using current year

For additional information on the date command, use:

man date<Enter>

Press Q to exit man program.

5.10 Synchronizing Time:

Contact AES Technical Support for options to synchronize two or more MultiNet

Receivers to the same time standard. This is important in any system where

servers share files.

5.11 Time Zone:

Time zone is also very important as time is kept internally in UTC and is set or

displayed according to a variable that identifies the Time Zone the MultiNet

receiver is located within.

By default, a MultiNet Receiver is typically set to Eastern Time Zone or

America/New_York.

The Setup program accessed by entering the setup command shown below on a

command prompt is the easiest utility to use for setting the time zone.

Setup<Enter>

You can also use the following utility, but Setup described above is usually easier.

Enter the following command to use the Time Zone Select utility:

tzselect<Enter> command to set the time zone. Follow instructions and answer

the questions presented on the screen.

Contact AES Technical Support for additional information on adjusting the Time

Zone on your MultiNet receiver.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 110 111

Sem comentários

AES 7170 Manual do Utilizador Página 24